|
One of the most effective methods of drifting a fly through deep
pools in Great Lakes steelhead rivers is to use a "slinky rig".
One of the key ingredients, of course, is the slinky. You can buy
slinkies from most steelhead shops, but you will pay a premium for
them. On the other hand, the components are pretty cheap and they
are very easy to make at home. You also have total control over
the weight inside the slinkies, so you can make them as light or
as heavy as you like. Indeed, you can make a variety of sizes to
match whatever conditions you might find.
You don't need much in the way of special tools or components.
The only specialty stuff is the round shot and parachute cord. The
shot I use is steel and is probably ball bearings of some sort (I
bought it in a kit), but any round shot will do. Removable shot
doesn't work as well 'cause the little tabs you use to open the
shot tend to get caught in the cord as you're trying to load it.
They will work in a pinch, though.
In a half-an-hour or so, you can make a season's worth of slinkies.
|
|
| You don't need many tools
to make slinkies. A candle, a pair of needle nose pliers, a needle,
a pair of scissors, some parachute cord, and some round shot of some
sort. That's it. |
 |
|
| First, you gotta seal one
end of the cord, so the shot won't fall out when you're loading it.
Just hold it next to the flame until the ends begin to melt. |
 |
|
| The edge of the cord gets
molten, like this... |
 |
|
| ... and then you just crimp
it shut with a pair of pliers ... |
 |
|
| ... and this is what the end
looks like after it has been crimped. |
 |
|
| Now you cut the slinkie cord
to length, Make it a little long, 'cause the edges tend to fray when
you're putting in the shot. |
 |
|
| Load the shot in the open
end. Notice how it frays a little bit? |
 |
|
| This slinkie has three shot
inside. There's room for another, or you can just trim it now. |
 |
|
| Trim some of the frayed ends
... |
 |
|
| ... melt the end in the flame
... |
 |
|
| ... crimp it shut ... |
 |
|
| ... and you're done. Well,
almost. You still have to put a hole in one end for the snap swivel.
|
 |
|
| Since you're going to be heating
the needle to melt a hole in the slinkie, you will need some sort
of heat proof handle. Don't try to heat the needle while you're holding
the needle itself. Mine is epoxied in a cork bottle stopper. |
 |
|
| Heat the needle over the flame
... |
 |
|
| ... and push the needle through
the melted end of the slinkie. The needle has to be really hot to
melt the hole, so it sometimes takes a couple tries before you get
the needle hot enough to melt the hole. |
 |
|
| You'll get a nice permanent
hole in your slinkie like this, which will make changing slinkies
much easier than if you just tried to punch the swivel through the
cord itself. |
 |
|
| That's it. I made this handful
in about 15 minutes. |
 |
Submitted June 18th 2008
What size parachute cord should I use?