Published Aug 25. 2015 - 8 years ago
Updated or edited Feb 27. 2019

Set up

Assemble Tubes - Junction tube has been jammed up onto the rear taper of the tube. Liner tube extends 3 mm behind rear of barbell tube and joined with Junction tube by thread wrap over front of junction tubing.
Set up
Steve Egge
Used in "The Barbell Tube"

Comments

Submitted by Glenn Roberts on Wed, 2010-08-11 11:03
Steve Great looki...

Steve

Great looking fly. But I don't understand or see (doesn't show in picture) how liner tube is joined to junction tube with thread wrap over front of junction tube. Would it not be easier to melt the read end of the liner tube up against the rear of the bullet tube (and then add junction tube)...as you do to finish the fly off after the conehead?

Tight lines.

Glenn