Preparations done for leveling and sanding

The blank is covered with masking tape and a bearing is placed on a masking tape bushing to avoid any harm to the blank. At the rear end of the blank I have placed a reinforcement wrap of masking tape. Tools from left to right: two sharp chisels, head of drilling machine with prepared chuck to fit the butt end of the blank. Caliper for measurings during the turning process and on the right the stand for the bearing and the necessary C-clamp behind it. In the background the end of the vacuum cleaner hose.

Photo/illustration: Jan-Ole Willers ©2015

Want to comment this page? Fill out the form below.
Only comments
in English
are accepted!

Comentarios en Ingles
solamente, por favor!

Your name Your email
Anonymize my information. Name and email will not be shown with comment.
Notify me on new comments to this article on the above email-address.
You don't have to comment to start or stop notifications.

All comments will be screened by the GFF staff before publication.
No HTML, images, ads or links, please - we do not publish such comments...
And only English language comments will be published.
Name and email is optional but recommended.
The email will be shown in a disguised form in the final comment to protect you against spam
You can see other public comments on this page