The Global FlyFisher - The Largest and Best Place to go for Online Fly Fishing and Fly Tying
First published before January 1st 2001 - More than 14 years ago
The Cone Head Tube Fly
A brand new way of tying tube flies
By Oivind Urkedal
The usual way of weighting a tube fly is by using copper or aluminum tubes. This article shows a totally different approach
Once in a while I read about a fly that I think looks like a killer and I tie it and try it. Usually I don't have any more success than with my standard patterns.
This has happened to me several times but I never give up trying new patterns
(does this sound familiar?). So when I read about the Cone Head Tube Fly in
an article written by Mikael Frödin - a superb Swedish flytyer - I thought as usual:
"This does look interesting".
The first trip to the river I got nothing...
The next trip I got three salmon in less than 90 minutes...
No surprise that I felt that this was a special fly, and even if there where several far more experienced fishers in the river, I was the only one that got any fish. After an exciting trip like this I just couldn't use any other fly.So what's making this fly so different from other tube flies?
Of course it's the head. By using a metal cone head you will eliminate the weight of the treble or double hook and the fly will have a jig-like motion when you retrieve it (depending on the current). In strong currents you'll have a fly that hardly ever drags. So the cone head give you "new" behaviours both in strong currents and slow waters.
If you know how to make a tube fly you know how to make a Cone Head fly.
When you have inserted the inner tube well through the head, you must melt the protruding part down towards the head, making a plastic cuff. This will prevent the head to slip off the tube. Use a lighter or a candle and rotate the tube while putting the head close to the flame. Be careful: Don't get to close to the flame as it can catch fire or melt too much. Also make sure that the inner tube isn't clogged by melted plastic. If this happens, you can use a bodkin to open up the inner tube.
Insert the inner tube in the outer tube before you tie the fly. If you tie the fly on the outer tube first you will probably have difficulties inserting the inner tube due to the compression of the tube that the tying-thread makes. You can use you favourite pattern with this type of fly. I prefer using a short tube (2 cm or 3/4") and rather short wing (about 4 cm or 1˝"). This makes a small fly that will take most benefit from the weight of cone head. It will dive and jig when you wiggle your rod tip or retrieve with short pulls.