DIY Epoxy Rotor - Global FlyFisher

GFF logo



   

Wood and iron


You need a small piece of scrap wood. About 5x25 centimetres or 2x10 inches should do. Make sure you have short screws for wood and a short bolt to mount the motor.

Photo/illustration: Martin Joergensen ©2014




Want to comment this page? Fill out the form below.
Comment
Only comments
in English
are accepted!

Comentarios en Ingles
solamente, por favor!

Your name Your email
Anonymize my information. Name and email will not be shown with comment.
Notify me on new comments to this article on the above email-address.
You don't have to comment to start or stop notifications.

All comments will be screened by the GFF staff before publication.
No HTML, images, ads or links, please - we do not publish such comments...
And only English language comments will be published.
Name and email is optional but recommended.
The email will be shown in a disguised form in the final comment to protect you against spam
You can see other public comments on this page