Two ways

On top the inner tube is stuck all the way through the outer tube and melted in the rear. you tie on the small tube right in front of the outer tube and use a soft connection tube to hold the hook.
Below that the inner tube is only stuck partly into the outer tube, which is cut at an angle. You tie right on the connection, and using a connection tube is optional since the hook can go inside the outer tube.
The cone goes on AFTER the fly is finished.

Photo/illustration: Martin Joergensen ©2015

More pictures from this article

Want to comment this page? Fill out the form below.
Only comments
in English
are accepted!

Comentarios en Ingles
solamente, por favor!

Your name Your email
Anonymize my information. Name and email will not be shown with comment.
Notify me on new comments to this article on the above email-address.
You don't have to comment to start or stop notifications.

All comments will be screened by the GFF staff before publication.
No HTML, images, ads or links, please - we do not publish such comments...
And only English language comments will be published.
Name and email is optional but recommended.
The email will be shown in a disguised form in the final comment to protect you against spam
You can see other public comments on this page